Object position detection at the different stages of hot forging process
Customer /field / Equipment Manufacturer
Hot steel forging presses
In automated forging presses and complete lines the presence or position of the material to be forged must be monitored at several steps of the forging process. This varies according to the automated machines which are involved in the process. Before shaping the metal, it is necessary to check the position and the temperature of the piece in the forging area of the press. If the piece is loaded automatically with mechanical hands or robots, its position in the mechanical hands must be checked before loading and removal. The position of the forged pieces must be controlled also in the mechanical shears which are generally placed next to the press with a deburring function. A control of the forged piece takes place also when it is ejected on the conveyor.
In the hot forging process the steel temperature is around 900 °C. According to the press layout, more than one piece is worked simultaneously next to each other; a sensor with restricted angle of view is required to monitor the relevant area. Mounting is possible only directly on the border of the press, looking down into the respective working area, where temperature and grahite are very aggressive.
Previous solution / Competitor product
No previous solution. Presses and forging lines from Farina have been equipped for over 30 years with Proxitron hot metal detectors, as the most suitable product for a rough operating environment. End-users who have experienced Farina Presse and Proxitron sensors will buy again new forging lines from market leader Farina and expect them to use Proxitron sensors again. Also when existing machines are refurbished, rebuilt or retrofitted, Proxitron sensors become compulsory.
Hot Metal Detector in compact design. HMDs with fixed switching temperature are preferred as cost-effective and adequate solution. A short protection tube OL 31 is placed on the optic, with aperture 4 mm, to reduce the field of view and prevent the smallest possible inlet of contamination. Laser light unit DAK 308 is used for an easy and quick alignment on the object.
Advantages compared to previous solution or competition
Reliable, long service life and flexible use on different machines. One model for different tasks. Since it reacts to the temperature of the material to be forged, the hot metal detector also monitors its minimum temperature: this is a very important function, as it prevents a possible damage of the die due to too low temperature. In some workshops the HMD output signal is used also for counting purposes.
Do you have a similar application and would like to be advised?
Please fill out our application questionnaire for infrared sensors and send it to sales(at)proxitron.de. Our experts will answer you as soon as possible.